ATUT-CR - Motion sensor
You will check the conveyor belt speed in real time, without interrupting the operation of the installation.
// DESCRIPTION
What it is
The ATUT‑CR motion sensor converts the signal from an inductive sensor into a potential‑free square wave signal, which can be read by any drive mechanically adapted to its installation.
You can install it in conveyor automation systems to control belt speed and in suspended monorail control systems. Intrinsically safe equipment allows operation in mining facilities at risk of methane explosion.
The IP65 protection rating enclosure and a connecting cable up to 50 metres give you freedom in mounting it away from the controller.
Technical data
- ATEX certificate No.
- OBAC 14 ATEX 0202X
- Power supply voltage
- 2.5 ÷ 15 VDC
- Maximum supply voltage
- 15.8 VDC
- Supply current
- <10 mA
- Output parameters
- potential-free square wave signal, resistive, 1.2 kΩ and 2.02 kΩ
- Maximum connecting cable length
- 50 m
- Device category
- I M1
- Design type
- Ex ia I Ma
- Gas explosion group
- I
- Operating temperature range
- -20°C to 60°C
- Air humidity
- max. 95%
- Enclosure protection rating
- IP65
- Dimensions
- 125 x 55 x 55 mm
- Number of cable connectors
- 1
- Weight
- 1 kg
- Mechanical impacts
- low
// Classification
Category
Solutions